膜法水处理技术及研究进展

综述了反渗透、微滤、超滤、纳滤、渗透蒸发、液膜等几种常见膜技术的应用现状及进展情况 ,主要对反渗透膜的原理、流程、存在的问题及开发和利用情况进行了介绍。简单概括了近年发展起来的双极膜等新膜分离技术的开发研究。展望了膜分离技术的前景     

膜分离技术处理电镀废水的实验研究

采用纳滤＋反渗透2级处理系统浓缩回收电镀铜漂洗废水。实验结果显示：在△P=1．5MPa条件下进行浓缩．纳滤膜可以使料液浓缩近10倍。纳滤膜对Cu^2＋的截留率在96％以上，对COD的截留率在57％以上。在△P=3．0MPa条件下进行浓缩，反渗透膜可以使料液浓缩近10倍。反渗透膜对Cu^2＋的截留率在98％以上，对COD的截留率在67％以上。随着料液浓度的增加，纳滤膜和反渗透膜的截留率会降低。     

胰岛素废水处理工程设计

针对某医药公司在制取胰岛素过程中产生的高浓度废水，采用预处理（酒精回收-盐水投配-除油）-倒A2O-接触氧化-化学除磷组合工艺进行调试，其处理效果明显，出水各项指标均能达标，同时对工艺中存在的缺陷进行了分析。     

炼油污水的再生水除盐处理

为满足可持续发展的需要，燕化公司将其炼油污水的再生水除盐处理后回用于锅炉。从处理工艺的选择，到工艺设计、开车运行，为再生水除盐回用提供了经验。     

渗透法处理高盐废水的原理及工艺

高浓度含盐废水的主要处理方法有反渗透、离子交换、蒸馏等，目前处理成本比较高。为改变当前高盐废水处理成本居高不下的现状，受渗透的基本原理启发，以分析渗透法处理高盐废水的基本原理为基础，提出渗透法处理高盐废水的新工艺。以溶质氨的设计溶液为例，分析高盐废水处理的新工艺流程及工艺的可行性，井对比反渗透工艺，详细阐述新工艺的特点。经计算分析认为。基于渗透原理的高盐废水处理工艺可降低高盐废水的处理成本，可作为高含盐废水处理方法的一个新的研究方向。     

水平燃料填充床反向阴燃传播及其熄灭分析

根据单步反应机理(仅包括燃料的氧化),建立了一维非稳态燃料填充床反向阴燃的数学模型。通过简化模型参数及大活化能渐近分析,得出了定性描述燃料反向阴燃传播的两个方程。结果表明:随着空气流量的增大,阴燃温度是不断上升的,但由于受到反向空气风流的影响,阴燃温度的增长幅度是逐渐变小的;阴燃传播速度却呈现出先增大后减小直至熄灭的变化趋势。这种变化趋势与前人的实验结果相一致。通过定性分析得出:在气体流量为零的情况下,燃料仍然可以发生阴燃,而维持阴燃不断传播所需要的氧气量源于反应区域周围气体的扩散。此外,也分析了燃料特性参数(如密度、孔隙率、比热、导热系数及活化能)对燃料阴燃温度和阴燃速度传播的影响。     

Reverse logistics in the Brazilian construction industry

In Brazil most Construction and Demolition Waste (C&D waste) is not recycled. This situation is expected to change significantly, since new federal regulations oblige municipalities to create and implement sustainable C&D waste management plans which assign an important role to recycling activities. The recycling organizational network and its flows and components are fundamental to C&D waste recycling feasibility. Organizational networks, flows and components involve reverse logistics. The aim of this work is to introduce the concepts of reverse logistics and reverse distribution channel networks and to study the Brazilian C&D waste case.     

Reuse of wastewater for industrial needs: the Pontedera case

This paper presents result from an economic and technical point of view evaluation study, which has sought to establish the potential for replacing well-water that is currently used at the Piaggio industrial plant in Pontedera with recycled wastewater. The study is based upon a pilot wastewater treatment plant, which has been used to test wastewater treatment processes and to compare with achieved quality of recycled waters with that of water drawn on-site from physical/chemical pre-treatment and end with a reverse osmosis and air stripping stage. However, after the physical/chemical pre-treatment, the first option uses oxidation with ozone followed by activated carbon filtration, whereas the second method uses ultrafiltration. The first method is more effective at reducing chemical oxygen demand (COD) whereas the second method is more effective in removing bacteria. Nonetheless, both methods deliver water for re-use of a quality comparable with or better than that of well-water. In principle, the reverse osmosis permeate from either process could be re-used in all production phases at the industrial plant. However, the method base upon oxidation with ozone followed by activated carbon filtration is preferred, because, the process is simpler and continuous. The economic analysis of this process gives an estimated cost of Euro 0.55 per m³ for treated water. This compares favorably with other treatment processes and with the cost of other forms of water supply, which are projected to increase in any case.     

反渗透深度处理乳品加工业二级处理废水试验研究

采用砂滤、活性炭吸附和反渗透组合工艺深度处理乳制品加工废水。深度处理后出水指标CODcr、TP和硬度分别达到10、1 mg以下和20 mg/L以下,经反渗透组合工艺深度处理后的乳制品加工废水可以达到锅炉补水,冷却循环水等水质要求。     

蒸发-固化法处理垃圾渗滤液反渗透浓缩液的研究

采用蒸发-固化工艺处理垃圾渗滤液反渗透浓缩液。蒸发工艺可将反渗透浓缩液减量化,固化工艺可将蒸发残留液中的污染物稳定化。研究表明,蒸发残留液宜采用水泥和石灰混合料进行固化,混合料最佳水泥与石灰质量比约为1︰2,每100 mL蒸发残留液(质量约为120 g)最佳投加量为50 g。固化体含水率低于40%,抗压强度高于1.0 MPa,适合填埋处置,其浸出液污染物含量较低。采用硅酸钠和硫酸钙作为添加剂可加快固化速度,提高固化体的抗压强度。利用蒸发-固化工艺处理反渗透浓缩液可取得良好的经济和社会效益。